Ignore in Secondary gone? Vray for Rhino 3.6

[gbuschta]

Hi,

I want an object to throw shadow on a plane but I don't want the plane to be visible, just the shadow and the reflections.
As far as I remember in the "old" vray 2.0 this was done with: ignore in secondary
But in the new vray I can't find this option.
Is there any way to do this??

I found there is a wrapper thing, but I can't figure out how it works....

Thank you!

[konstantin_chaos]

Hi gbuschta,

The Ignore in Secondary option was not going to help in your case.
You can use the Matte_Shadow_Receiver material from the library Diagrammatic category.
It'll create a Wrapper material with the proper options set and a Generic material used as a base.
You should then apply the Wrapper to the geometry.

Note: If you also want to see reflections on the ground you can just make the Reflection color of the Generic material white.

Regards,
Konstantin

[gbuschta]

Hi gbuschta,

You can use the Matte_Shadow_Receiver material from the library Diagrammatic category.
It'll create a Wrapper material with the proper options set and a Generic material used as a base.
You should then apply the Wrapper to the geometry.

So, seems that I'm too stupid for that. - where do I find the library Diagrammatic category in Rhino?
Thank you very much for your help!

[gbuschta]

Found it, thank you!! It works!!!